Brightwell Aquatics PH+

Instructions and Guidelines

pH is always lowest a few hours after the main lights have turned off for the evening, and is highest a few hours after lights have been burning during the day. Adjust pH to remain with a range of 8.1 – 8.5 at all times. Before adjusting pH, ensure that the alkalinity in the aquarium is within a range of 7 – 12 dKH (2.5 – 4.3 meq/L). Determine the pH in the aquarium using an accurate test kit or recently-calibrated pH meter before using Brightwell Aquatics pH+. If the alkalinity is below the desired level, adjust this first and then allow 24-hours to elapse before re-testing pH, then add pH+ as directed below. [Alkalinity may be increased by using a buffer-type product according to the directions; again, an accurate test kit (for measuring alkalinity) should be used whenever bringing about a significant change to the alkalinity. Brightwell Aquatics’ Alkalin8.3 or Alkalin8.3-P (powder) are two buffer-type products that may be used for this purpose.]

Add this product at the maximum dosage of 5 ml per 20 US-gallons per 24-hours at the same time each day. pH will generally stabilize within 2 hours following product use, however livestock should not be subjected to a change in pH of more than 0.2 per 24-hour period, so do not overdose pH+. Repeat as needed to attain desired pH value. It is recommended that pH be maintained within a range of +/-0.2 at all times.

Caution: Contains carbonate salts; harmful if swallowed. If swallowed: give water, get medical attention. May cause eye or skin irritation. If in eyes, flush with water for 15 minutes, get medical attention. If on skin, wash thoroughly with water. Keep out of reach of children. Not for human consumption.

Guaranteed Analysis

Carbonate (min) 1,497mg/oz. (50,633 ppm)

Ingredients

Purified water, inorganic Carbonate salts